|
Blower Belt Guards |
| The RCD belt guard is incorporated into the starter face plate and consists of three sections which can be purchased separately.
The crescent shaped aluminum top guard covers the top 150 degrees of the blower sprocket and if needed, continues down the tension side of the belt to approximately 3" below the crankshaft. This guard offers protection for the fuel and oil lines, wires and clutch control lines that pass outside the blower belt. It also offers protection for the blower belt and starter while the engine is cranking and the starter is being removed.
For Funny Cars and Altereds, there is the added benefit of body panel protection.
The starter locks-on in the same manner as before offering unrestricted access to the top blower sprocket, allowing belt removal and blower ratio changes. The middle guard has two button holes located at its top. With its screws loosened, this piece slides out of the block bracket and the blower can be removed as usual. The main belt guard parts are available in aluminum .The complete set weighs 2 lbs. including the mounting hardware and starter bracket.
PN:103507-0004 Blower Belt Guard w/Starter Mount STD Roots
Top Guard- fits all root style Superchargers, Kobelcos, S.S.I., Screw and old style Whipple. Weight 1-1/4 lbs. |
 |
PN: 103507-50 Face Plate
w/Snout Clamp Funny Car PN: 103507-51 Face Plate w/Snout Clamp Dragster (Face Plate only - doesn't include guard) |
|
 |
